News

Common water pipes are mostly plastic pipes. When the cold climate is encountered, especially in open -air occasions, it is easy to appear crispy, frozen, blocked, and easy to corrosion. For such situations to choose an electricity with heat insulation, it can directly lay or wrap it on the outer wall of the pipeline, and directly or indirect thermal exchange compensation compensation for the heat loss of the accompanying heat pipeline. In addition, after the tuning is completed, installing the insulation cotton can effectively heat up and protect the pipeline without being eroded by the external environment. The following brief explains the selection and precautions of the anti -freezer of plastic pipes:

  Plastic pipelines are very common in daily life. Compared with the pipelines of other materials, the plastic pipes are lightweight and easy to install. However, the material of the plastic pipeline is not high and the heating is poor. Many users are worried about whether the tropical method of electricity will be burned. Of course, plastic pipeline insulation can be insulated using the electricity heating system. Some users may feel that plastic pipes will be burned by electricity with electricity. Temperature -limited tropical parts, the temperature of the electric heating surface does not exceed 85 ° C, and the temperature is self -controlled, and it will stop working when it reaches a certain temperature. In addition, the temperature controller can also use the temperature controller to control the temperature, so the burns can not occur.

       Regarding the problem of comparison of thermal conductivity of plastic materials, we can improve such problems in the installation method. In order to effectively guarantee the heat loss of the heat exchange compensation. In terms of electricity with heat installation, the heating area can be increased through aluminum foil tape to achieve uniform heating and effectively ensuring the safety of installation and use.

      At present, the pipeline anti -freezing selection of self -limited temperature with the tropics. Installing other heat products cannot be comparable. This is determined by the heating and parallel structure of the self -limiting temperature with the heat of the heating and the parallel structure. Cutting can be carried out according to the demand for on -site installation. For places where pipe valve, elbow, instrumentation, etc. are easy to freeze, it can achieve cross -wrap than overheating.

​